NAME
bl - draw a break-line between two points
FORMAT
:bl;=P1;=P2[;...]
LEVEL
1u
DESCRIPTION
The bl command draws a break-line between the two specified
points. The line-type will be automatically set to normal
(solid) and the line parameters are determined by the values
specified for pen, color, break marker size and break marker
spacing on the break-line status menu. (All dimensions are
specified in paper units.) The command repeats.
Once a set of typical parameters have been set on the status
menu, selecting the SAVE BREAK-LINE PARAMETERS button will
save these settings to disk. These values will then be
automatically set each time the break-line command is used
in a new ARRIS session.
PROMPTS
Break-Line: Enter 1st point (<CR>:exit)
Indicate the location for the start of the break-line,
or press <CR> to terminate the command.
Break-Line: Enter 2nd point (<CR>:restart)
Indicate the location for the end of the break-line.
Pressing <CR> restarts the command, prompting for a new
1st point.
ERROR MESSAGES
Second point cannot be the same as the first.
This indicates that the two points may not be identical.
Continue by selecting an alternate second point.
Distance between points is too small to insert break-line.
This indicates that there is not enough room between the
two specified points. The space between the two break-
line points must be at least 1/8" larger than the
current break marker size parameter. Continue by
selecting an alternate second point or press <CR> to
restart the command.
FILES
${GRUSR}/config.dir/cj_brkln.tx Break-line default param-
eters
FLAGS & PARAMETERS
#fcol, #flin, #flnfnt, #fpen
RELATED COMMANDS
:sal, :sln
AUTHOR
C. Jeffery Small (jeff@cjsa.com)
COPYRIGHT
Copyright c 1995-2006 by CJSA LLC
Man(1) output converted with
man2html